Aquarium Divider Clips and Feet for 2-4 mm Sheet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two glass clips and two base feet in one print to line up your own 2-4 mm divider sheet.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Standard Digital File License
Two clips that hang on opposite glasses and two base feet, all in one print, to line up your own acrylic or polycarbonate divider sheet.
If you already have a divider sheet, these line it up. The clips hang on the top edge of two opposite glasses, each with a 12 mm deep channel for the sheet's edge; the feet take the bottom corners. Cut the sheet 8–14 mm narrower than the inside width of the tank and about 15 mm below the top of the glass. The clips sit on the glass by their own weight and do not lock the sheet: a push of a few grams moves them.
What it fits
Rimless glass 4, 6 or 8 mm thick.
Divider sheet 2, 3 or 4 mm thick: acrylic, polycarbonate, PETG or solid rigid PVC (solid or perforated).
Clips stop above the water: for a water level about 30 mm below the top of the glass.
What you need
PETG filament.
Your divider sheet, cut to size.
Print settings
Material: PETG
Nozzle: 0.4 mm
Layer height: 0.2 mm
Walls: enough to fill the parts
Infill: 100% — air inside a sparse infill can float a clip or a foot
Supports: None
Orientation: Upside down, as in the file.
Bed: One file holds two clips and two feet: 106 × 25 × 28 mm.
Files
divider-clips-and-feet_glass{4|6|8}mm_sheet{2|3|4}mm.stl— nine files: pick your glass and your sheet
Fitting
Slide each clip over its glass; it should go on with a light push.
Stand the feet on the substrate and lower the sheet into the channels.
Limits
Not for sheets that float or barely sink (polypropylene, polyethylene, polystyrene, foam board).
Not for a current pushing across the sheet: the clips are not clamped.
Fish that jump can still get over the top.
How it was checked
Checked by simulation, not printed by us yet: the geometry is checked for fit (clearances), wall thickness against a 0.4 mm nozzle, bed size and overhangs. Loads are not simulated. If it does not fit, a comment with your measurements helps.
Safety
Use PETG for parts that sit in the water.
A parametric version of this part is on mislastudio.com: https://mislastudio.com/m/presilha_divisoria?utm_source=printables&utm_medium=free_model&utm_campaign=presilha-divisoria
Designed by Misla, a small studio of engineered 3D-printable parts: https://mislastudio.com/?utm_source=printables&utm_medium=free_model&utm_campaign=presilha-divisoria