Boxturtle LDO Voron Trident 300 Hard-Mounts with Handles

The LDO Voron Trident 300 Rev.D+ kits are shipped with handles which can be installed on the ceiling extrusions (on top of 3mm foam tape + 3mm polycarbonat panel). Unfortunately, the boxturtle hard mounts cannot be installed next to the handles because they are too wide. And even when they could be installed, they are too small and the handle is blocked by the boxturtle.

The overall structure of the legs was modified to elongate them to give more space for the fingers. The (6mm) spacers for the handles are also directly integrated to make sure that the they are not conflicting with the legs.

BOM:

• structural mounting of boxturtle

  • 12x M3x10 SHCS screws

  • 12x M3 washers

  • 12x M3 roll in nuts

• handle mounting

  • 4x M5x16 SHCS screws

  • 4x M5 roll in nuts

Please make sure to use the M3 screws with washers for structural mounting. Only using the M5 screws for the handles is not enough to securely mount the boxturtle on top of the ceiling extrusions.

Print setting:

• Material: ASA/ABS

• Layer height: 0.2mm

• Extrusion width: 0.4mm

• forced Infill percentage: 40%

• Infill type: gyroid

• Wall count: 4

• Solid top/bottom layers: 5

• Supports: NONE

• calibrated shrinking settings for used filament

It is recommended to first install the legs on the boxturtle. Leave the M3 screws slightly loose and pre-adjust the distance of the right/left side of the legs by holding the handle between the legs. Only then tighten the M3 screws more. But keep in mind that you might still need to loosen them again when putting them on top of the Voron Trident.

When moving the boxturtle enclosure to the top of the LDO Voron Trident 300 Rev.D+, align the M3/M5 roll-in nuts in the ceiling extrusion before pushing the legs in the extrusion. A pair of additional helping hands for holding the boxturtle enclosure can be quite useful.

Make sure that you can actually screw in everything before finally tightening the screws completely.