TP-Link Omada Access Point Rack Mount for 19" and 10" Racks (EAP610 / EAP613 / EAP650 / EAP653, 4U)

Holds a TP-Link Omada ceiling AP upright in a 19" or 10" rack, facing out. A 2U ear screws to one front rail; the AP’s own bracket bolts to the plate, so the AP twists on and off as it does on a ceiling. 204 x 160 x 11 mm, about 98 g.

Compatible Access Points

• EAP610: tested

• EAP613, EAP650, EAP653: same size and bracket; check yours on the fit test

Too big: EAP670, EAP673.

Rack Requirements

• 4U of height, and 188 mm of opening beside the rail (a 10" rack has about 222 mm)

• 7 mm of depth behind the rail; the AP stands about 34 mm in front of it

Features

• Left- and right-rail versions

• 6 slotted M6 holes on the standard rack pattern

• Round plate the AP’s size, hidden behind it

• Ribbed and open at the back

• Engraved Kaiju Labs logo; unbranded versions included

• One-layer fit test for the bracket

Print Settings

• PETG, front face down, no supports

• 0.2 mm layers, 4 walls, 25% gyroid, 4 top / 4 bottom layers

• Print the fit test first

Hardware Needed

• 2 x M6 cage nuts and M6 x 12-16 mm screws with washers

• 4 x M3 x 10 mm bolts, washers and nuts

Assembly Notes

1. Lay the bracket on the fit test (rim and lugs up) and check the holes line up.

2. Bolt the bracket to the plate, notch up, nuts on the back.

3. Screw the ear to the rail through the top and bottom holes. Don’t over-tighten.

4. Twist the AP onto the bracket until it clicks.

Files

• omada_ap_rack_mount_left.stl: left rail

• omada_ap_rack_mount_left_nologo.stl: left rail, no logo

• omada_ap_rack_mount_right.stl: right rail

• omada_ap_rack_mount_right_nologo.stl: right rail, no logo

• omada_ap_rack_mount_fit_test.stl: bracket fit test

• omada_ap_rack_mount_print.3mf: 3MF project with both mounts and print settings, opens in any slicer that reads 3MF