1 / 5
Front brace/locking barrel assembly for Salt Strike v1 — zdjęcie 1
1 / 5

Front brace/locking barrel assembly for Salt Strike v1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

a mod for the front end that is either held by the bands, or glued to the front to support locking barrel system

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
15
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Add on for the Salt Strike. Its a locking barrel system that attaches to the front via rubber band pressure (works 100% fine) or gluing directly to the frame. The barrels all have a o-ring cutout at the base to seal to breach when barrel is inserted. One notch on the barrel meets a cutout in the unit and slides, twists and is locked in. seals fantastically and prints quicky. would recommend PETG. Eventually ill get all the files together into one 3mf for the whole salt strike with mods and add ons but not today lol. 

The barrels include 1 6.08mm Airsoft barrel

2x Salt shooter barrels which are the tall skinny ones i believe the inner diameter of the barrels are 1.80 and 2.50 for differnt loads.

1 Stubby salt barrel for wide spread (experimental)

Shorter smoothbore barrel which is the easy one its made for full flow so its good for toothpicks, q tips, shooting filament, anything that will fit. 

FOR SALT BARRELS THIS IS VERY IMPORTANT- When loading salt into long barrels. load from the breach side as the holes and steps inside the barrel prevent salt from dumping out the front. The breach (cone part of barrel) works best between 1/3 and 1/4 way full. NOW, heres the kicker, the salt barrels will give you between 6-7 shots depending on variables. I actually have a couple kills confirmed on the bigger diameter salt barrel as of today so the print DOES WORK if you loaded too much you will know, just keep cycling and itll even out. Ive had over 200 shots through this system so far 

you can TRY to print in pla if you want but i would advise against it. Only post print process is sanding where the barrel slides in on the front plate. its a tight fit (intentionally) a couple passes with 800 grit wrapped around a screwdriver will do it dont go crazy

Tagi