Climbing/Bouldering wall adapter for JOBY GorillaPod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-on cap for a JOBY GorillaPod rubber foot with a peg that plugs into a climbing-wall bolt hole (M10 T-nut)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
The cup grabs the ~24.3 mm rubber ball foot: its lip is narrower than the foot, and slotted fingers flex open so the foot snaps past and sits in a spherical seat. The seat is a "teardrop" (sphere + 45 deg cone roof) so it prints with the opening on the bed and no supports. The peg on top is sized to slide into the M10 thread of the T-nut; small crush ribs make it hold.
An M4 bolt runs up the peg's axis: head in a pocket in the seat roof, nut on the peg tip. Tightening it clamps the peg's layers together, so bending loads (which pull the layers apart) go into the steel instead.
Print: PETG (PLA OK for a test), 0.2 mm, 4 walls, 15-25% infill, opening down / peg up as modeled, no supports.