1 / 4
Climbing/Bouldering wall adapter for JOBY GorillaPod — image 1
1 / 4

Climbing/Bouldering wall adapter for JOBY GorillaPod

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Snap-on cap for a JOBY GorillaPod rubber foot with a peg that plugs into a climbing-wall bolt hole (M10 T-nut)

Rating
0 / 5
Likes
1
Downloads
1
Makes
0
Views
14
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

The cup grabs the ~24.3 mm rubber ball foot: its lip is narrower than the foot, and slotted fingers flex open so the foot snaps past and sits in a spherical seat. The seat is a "teardrop" (sphere + 45 deg cone roof) so it prints with the opening on the bed and no supports. The peg on top is sized to slide into the M10 thread of the T-nut; small crush ribs make it hold.

An M4 bolt runs up the peg's axis: head in a pocket in the seat roof, nut on the peg tip. Tightening it clamps the peg's layers together, so bending loads (which pull the layers apart) go into the steel instead.

Print: PETG (PLA OK for a test), 0.2 mm, 4 walls, 15-25% infill, opening down / peg up as modeled, no supports.

Tags