Zilla Gen-1 PM Block — Programmable-Matter Cube Chassis (50mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
50mm programmable-matter cube chassis: six face plates + core cradle. Support-free. AI-assisted CAD, watertight STL.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 3
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
The physical Gate. This is the 3D-printable chassis for Zilla Gen-1 — a 50mm programmable-matter block: hand-placed smart magnetic cubes whose coupling is governed by a deterministic safety kernel. The payoff demo: a block that refuses a forbidden detach because the kernel said no.
WHAT'S IN THE FILES
- Face plate (x6 per block): 50x50x4mm, 45-degree chamfer, EPM pocket dia 10.5, 4x M3 pilot holes
- Core cradle (x1 per block): open tub, full tray, battery retainer, perfboard standoff pads
- Both parts print support-free: plate outer-face down, cradle tray down
HONEST STATUS — v1.0 CAD
Both STLs are verified watertight in CAD. Nothing is printed yet — first print is in progress, and every dimension is an estimate until calipers say otherwise. First-print checklist: interior is 42mm (not 46); wind one coil and measure its OD before printing all six plates; verify the 602030 battery bay against your actual cell before printing all four cradles.
PRINT SETTINGS (starting point)
0.2mm layers, 3 walls, 20% gyroid infill, PLA.
ELECTRONICS (not included — shell only)
ESP32-C3 Super Mini, 602030 LiPo, 6x EPMs per block, perfboard. Firmware answers MOVE with ERR_INVALID_COMMAND: Gen-1 blocks don't move. Locomotion is Gen-1.1, gated behind proven magnets and a proven gate.
AI-assisted design, verified watertight STL. Images shown are CAD previews rendered from the actual STL geometry — not printed parts.