Voron 0.2 Kirigami Bed ***No Inserts*** (WIP)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Using captive nuts to eliminate the need for heat set inserts
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
I ordered 3 Voron 0.2 kits from Siboor. After assembling the first I realized I really don't like inhaling all those styrene fumes when heat-inserting heat-inserts, so I desided to try to do the next two with no heat-inserts. After all, I am hand-"soldering" them, and the results are not very accurate. I believe I can get much better results with properly captivated nuts.
Those are captive nuts, not embeded nuts, so no need to stop the print to embed the nuts. You push them into dedicated slots or bores after printing, like with Prusa printed parts.
Prepare the same amount of m3 hex nuts as you would heat set inserts.
This project focuses on the Kirigami bed mod printed parts.
Instructions:
1. Print like you'd print all Voron parts.
2. Specific part instructrions:
2.1. Kirigami_V0.2_stealth_chain_release parts - VORON_v0.2_stealth_chain_mount v2-1__Body1-no_inserts: use m3x8 instead of m3x6 and m3x12 instead of m3x10 bolts.
Lisence is derived from the github https://github.com/christophmuellerorg/voron_0_kirigami_bed which in trun derives from Voron's original parts - GPL V.3.0