Ender 3 Direct Drive - BMG + E3D V6 + BLTouch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was not satisfy with the original solution, so I tried to modify it as follow: BLTouch support in front of the body…
- Ocena
- 5 / 5
- Polubienia
- 64
- Pobrania
- 409
- Wydruki
- 1
- Wyświetlenia
- 5736
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1.5.2022: Just note - this design is obsolete, better version in all ways is here
I was not satisfy with the original solution, so I tried to modify it as follow:
- BLTouch support in front of the body (I didn't want to block air flow from the side cooler).
- Duct is closer to the nozzle and flows more accurately.
- Duct is higher so it doesn't cover view to the nozzle and also doesn't accidentally "touch" paper clip which I use as glass holder.
Duct, BLtouch holder, 5015 FAN holder use M3 DIN934 nuts and M3 screws.
Rev. 3 @16.1.2021
Cable holder added
Rev. 2 @ 6.1.2021
Few small modification in the source files.
BLTouch offset: -27,2mm in X; -31,4 mm in Y. Z axis is up to you (please follow manufacturer instruction).
Rev. 1
Both body parts are screwed together by two M3x22 DIN912 screws and M3 nuts (see attached picture).
Thanks to @Kiron and also @Leovade
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
ca 20%
Filament: Prusament PETG Various
Notes:
Print the Duct as shown on the picture. Is necessary to use enforcers support on few areas.