1 / 23
Flywheel vehicle  "remix of #3566283" — zdjęcie 1
1 / 23

Flywheel vehicle "remix of #3566283"

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix for the flywheel powered car #3566283. So far thing-i-verse has not let me add the remix info in the…

Ocena
4 / 5
Polubienia
11
Pobrania
40
Wydruki
0
Wyświetlenia
408
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a remix for the flywheel powered car #3566283. So far thing-i-verse has not let me add the remix info in the right place. https://www.thingiverse.com/thing:3566283

Demo and build video on youtube. https://youtu.be/hgVMQ4UHOGA

So I changed the body frames to have stops to keep the bearings in place.

I split the axles so they can print with out supports and are held together by the gears and bearings.

I changed the flywheel from a few metal nuts for mass too using large flat washer's with a inside hole of 1/2 inch and outside of 2 inches.

I changed the wheels to 3d printed ones with rubber O ring tires.

I changed the gears to 1 percent larger and be sure to print the gears with no elephants foot so the gear teeth on the bed are clean. I us Prusa slicer as it has a Advanced setting for this.

I did not change the gear design but should have. They have a very fine pitch, a gear design with less teeth and deeper teeth would be better.

So all parts print with no supports.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%

Filament: any PLA any


Notes:

Print gears with no bed elephants foot so you do not have to clean up all the small gear teeth.

Category: Mechanical Toys

Tagi