Antonov An-255 model

This Antonov An-255 model has a cargo bay door that opens at the front, spinning blades, and a very nice model. You can put it right on your desk or use the stand. You will need some super glue to assemble this model.

Quantities:

1 of everything except the following:

• 6 Engine casing

• 6 Turbines

• 6 Exhaust

• 2 Body Pins

Assembly:

1. Using the aligning pins connect the forward and back parts of the fuselage together and glue.

2. Insert the wing connector into the slot in the forward fuselage

3. Glue the left and right wings onto the wing connector where it extends past the fuselage.

4. Glue the elevators onto the body attaching them to the elevator connector and sliding it into the corresponding slot on the back of the fuselage

5. glue the cargo bay rod onto the cargo bay.

6. Gently snap the cargo bay rod into the forward cargo bay in the slots on the front of the body.

7. Snap the nose connection rod onto the clips on the front of the body.

8. Center and glue the exhaust pipes onto the back of the turbines

9. Glue the exhaust turbine assemblies into the engine casing, with the back of the exhaust attaching to the back of the engine casing.

10. Glue the engine casings onto the body, aligning the additional slots on the top of the assembly to the cutout in the bottom of the wings.

Print Setings:

• Plate 1 (Body Elements)

  • 0.4 mm nozel

  • 0.16mm High Quality

  • Supports

    • Tree

    • Threshold angle 25

    • Support critical regions only

• Plate 2 (Engine Assembly and Cargo Bay)

  • 0.2mm nozel recommended (Can use 0.4) 

  • 0.8mm High Quality

  • No Supports