Build Bed Stabilizer V 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7t0VmBQPj1k This is my final…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/7t0VmBQPj1k
This is my final version of a bed stabilizer for my Solidoodle 3
Instructions
A small compression spring approximately 1.5 inches long is centered and pinned in place thru small hole in center section. 2 11 x 5 x 4 mm bearings are held in holders by plastic pins. 2 3/16 inch steel rods are cut to approximately 5.25 inches 1 end is ground down to fit in bearing holders . 2 screws threaded into center section keep it tight on build bed base.
Category: 3D Printing