goBILDA Yellow Jacket Motor Conversion FTC BIOBUZZ

Overview

This is a custom-designed, 3D-printable mechanical adapter developed for a goBILDA Yellow Jacket motor configuration used in FIRST Tech Challenge (FTC) robotics.

I designed this part to address a mechanical interface compatibility issue in my own setup when a suitable ready-made component was not available for the configuration I needed.

The adapter is intended to connect the required mechanical interfaces in this specific setup. The design was modeled in CAD, 3D printed, and tested for physical fit.

Features

• Custom CAD design by JANUS Studio

• 3D-printable construction

• Designed for a specific goBILDA Yellow Jacket motor configuration

• Developed to address a mechanical compatibility problem in an FTC robot

• Physically printed and fit-tested

Important Notes

• Please verify your motor model, shaft dimensions, and mechanical interfaces before printing.

• Compatibility with other Yellow Jacket variants or drivetrain configurations has not been established.

• Physical fit testing does not establish load capacity, long-term durability, or safe operation at 6000 RPM.

• Further testing is recommended before using the part in a powered drivetrain.

Printing

Print orientation, material, infill, and wall count should be selected according to the part geometry and intended mechanical loads. These settings should be validated for your own application.

About JANUS Studio

JANUS Studio creates custom CAD designs, functional 3D-printable parts, and mechanical solutions for robotics and engineering projects.

If you use this design, feedback and photos of your print are welcome.

Designed by JANUS Studio.