Wall Mount for SONOFF Zigbee Dongle Plus MG24 (Dongle-PMG24)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clean, minimal wall mount that holds the SONOFF Dongle Plus MG24 vertically with the antenna pointing straight up for th
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I run Home Assistant on a Raspberry Pi 5 with an NVMe HAT. To avoid USB 3 and PCIe interference, the Zigbee dongle should sit away from the Pi on a USB extension cable. This mount lets you screw the dongle neatly to the wall so it hangs perfectly straight instead of dangling behind a cabinet.
Features:
Two snap-in clips with rounded edges: the dongle clicks in from the front and stays put
Antenna points straight up, USB cable exits at the bottom
Two countersunk screw holes hidden behind the dongle
Centerline notches at the top and bottom for easy vertical alignment on the wall
Prints flat, no supports needed
Compatible with: SONOFF Zigbee 3.0 USB Dongle Plus MG24 (model Dongle-PMG24). Not tested with the older ZBDongle-P or ZBDongle-E, which have different housings.
Tip: keep the dongle away from your WiFi router and connect it to a USB 2 port on the Pi for the most stable Zigbee network.
Print settings
Setting | Value |
|---|---|
Orientation | Flat on the bed, as provided |
Supports | None |
Material | PETG recommended (clips need some flex), PLA works too |
Layer height | 0.2 mm |
Perimeters | 3 |
Infill | 15 to 20% |