Liczymy pasujące modele…
I made a thread mesh monitor and part of it uses a Seeed Studio Xiao MG24 running the OpenThread RCP (“radio co-processor”) firmware. The issue I have is that the MG24 circuit board is vulnerable to being short-circuited against anything…
Wydruk około 0,13 €–0,16 € nettoWstępna wycena dla PETGMateriał u źródła: PET
A simple and sturdy mount for the Sonoff Zigbee & Thread Dongle Plus (MG24). This holder provides a snug fit for the dongle and includes enough space to accommodate the included USB extension cable for better signal placement. There are…
Dies ist eine Kleine Halterung für die Sonoff Dongle Plus MG24 Montage Möglichkeiten Schrauben, Kleben oder mit max. 6 Magneten 5 x 3 mm die Aussparungen schon auf der Unterseite vorhanden. Diese Halterung ist so konstruiert dass das…
XIAO MG24 is an ultra-low-power wireless development board based on Silicon Labs' EFR32MG24 SoC, featuring a high-performance 78MHz ARM Cortex®-M33 core. It‘s Matter® native over Thread® and Bluetooth® Low Energy 5.3, all supported by the…
The SONOFF Dongle Plus MG24 is a USB device that comes without an additional holder. If you want to mount this dongle properly, you have to construct a holder yourself. I have designed a holder for the Skadis wall from Ikea. I also…
Ikea Skadis mount for Sonoff Dongle Plus MG24
I run Home Assistant on a Raspberry Pi 5 with an NVMe HAT. To avoid USB 3 and PCIe interference, the Zigbee dongle should sit away from the Pi on a USB extension cable. This mount lets you screw the dongle neatly to the wall so it hangs…
Slide the antenna inside the case. I printed it in PETG with 0,2mm layer height.
Holder for the Sonoff MG24 Stick. This was made completely by AI (Anthropic's Claude). I have no idea of the quality of the model and the scad file. Please be aware of that. Printing though worked fine for me.
Here is a simple bracket to mount the Sonoff Plus MG24 USB Zigbee/Tread dongle. Just add 2 little screws. I printed it in PETG.
This holder is used to mount Sonoff Plus MG24 to the top of 35mm tube which holds monitors
I couldn't find a mount that suited my needs, so I decided to make my own. I found a similar design available for purchase and used it as inspiration for my model. The dongle is mounted at a 45-degree angle. I think this looks much nicer…
