Boot Jack - Pull Off Wellies and Boots Without Bending Down, No Supports (OpenSCAD)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pull off wellies, riding and hiking boots hands-free: stand on the back, heel in the notch, lift your foot out.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Pull off wellies, riding boots, hiking boots and work boots without bending down or getting your hands muddy. Stand on the back with one foot, put the heel of the other boot in the notch and lift your leg out. The notch has a soft round edge so it doesn't scuff, there are grip grooves where you stand, and the riser underneath lifts the front.
DETAILS
• 210 x 80 mm, 9 mm thick board, 28 mm riser, 34 mm notch.
• Prints flat with no supports: the riser is printed on top, so the smooth bed side is the side you stand on. PETG is tougher than PLA for this.
• Bambu Studio: 1 h 43, 63 g.
CUSTOMIZE (OpenSCAD)
Length, width, notch width and riser height.