Snap-Lock Hooks for IKEA Skadis: They Can't Be Knocked Off
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skadis hooks with a built-in snap latch: print flat, no supports, no screws, no springs. Lift to release.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 65
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Standard Digital File License
Ordinary Skadis hooks fall out when you pull a tool away. These ones lock themselves: a flexible finger with a wedge-shaped nub, printed in the same piece, drops into the free part of the slot as soon as the hook slides down, so the hook cannot lift out by accident.
Push the hook through the slot (raised about 5 mm), let the nub ride on the board face, slide it down: it clicks into the slot.
To remove: lift firmly. The 56 degree ramp on the nub pushes the finger out, no tool needed.
Printed flat on its side, so the finger flexes in the layer plane (strong, no layer splitting). 0 supports.
Two variants: J-hook (50 mm reach) and tilted peg (70 mm reach, slight upward tilt keeps things from sliding off).
Slot clearance: 4.4 mm wide hook in the 5 mm slot, 15 mm slot height, board 5 mm.
Print settings: Bambu A1, PLA, 0.20 mm layer, 2 pcs of one variant: 22-23 min, 7 g. PETG works too (the finger is 1.6 mm thick, deflection about 2.6 mm).