1 / 3
Snap-Lock Hooks for IKEA Skadis: They Can't Be Knocked Off — image 1
1 / 3

Snap-Lock Hooks for IKEA Skadis: They Can't Be Knocked Off

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Skadis hooks with a built-in snap latch: print flat, no supports, no screws, no springs. Lift to release.

Rating
0 / 5
Likes
3
Downloads
2
Makes
0
Views
65
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Standard Digital File License

Ordinary Skadis hooks fall out when you pull a tool away. These ones lock themselves: a flexible finger with a wedge-shaped nub, printed in the same piece, drops into the free part of the slot as soon as the hook slides down, so the hook cannot lift out by accident.

  • Push the hook through the slot (raised about 5 mm), let the nub ride on the board face, slide it down: it clicks into the slot.

  • To remove: lift firmly. The 56 degree ramp on the nub pushes the finger out, no tool needed.

  • Printed flat on its side, so the finger flexes in the layer plane (strong, no layer splitting). 0 supports.

  • Two variants: J-hook (50 mm reach) and tilted peg (70 mm reach, slight upward tilt keeps things from sliding off).

  • Slot clearance: 4.4 mm wide hook in the 5 mm slot, 15 mm slot height, board 5 mm.

Print settings: Bambu A1, PLA, 0.20 mm layer, 2 pcs of one variant: 22-23 min, 7 g. PETG works too (the finger is 1.6 mm thick, deflection about 2.6 mm).

Tags