Skeleton Claw Grabber - Bony Lazy-Tongs Arm with Snapping Skeleton Hands, Halloween Toy (No Supports)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Squeeze the finger loops and this bony arm shoots out to 34 cm while two skeleton hands snap shut on a sweet.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 230
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Autumn & Halloween
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Squeeze the finger loops and this bony arm shoots out across the table while two skeleton hands snap shut on a sweet, a sock or a little brother's ear. Open your hand and it folds back up. Perfect for stealing sweets from the Halloween bowl.
HOW IT WORKS
• Four X pairs of bones on ten snap pins: a lazy-tongs arm. Close the loops and every X narrows, so the arm grows from 18 cm to 34 cm and the hands close at the same time.
• The bones lie in two layers. The hands are as thick as both layers, so they meet face to face, and that stops the squeeze.
• Handles, bones and hands are one design each, printed twice: turned over, a piece becomes its partner on the other side.
PRINTING
• One plate, no supports: 2 handles, 4 bones, 2 skeleton hands and 12 snap pins (2 spare).
• The 3MF is set up in bone white with black pins.
• Bambu Studio: 1 h 42 and 32 g.
ASSEMBLY
Lay one handle, two bones and one hand flat side down in a row, all leaning the same way. Turn the other handle, two bones and hand over and lay them across the first row to make four X's, hands at one end and finger loops at the other.
2. Push a pin up through the middle of each X, then through each joint where two X's meet, until the barb clicks.
3. Squeeze, grab, repeat.
CUSTOMIZE (OpenSCAD)
The clearance on the pin holes.