ESP32-S3-DevKitC-1 (N16R8) Slide Case – Pin Header Support & Integrated Buttons
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A snap-fit sliding enclosure designed for the ESP32-S3-DevKitC-1 (N16R8) with soldered pin headers. Features integrated
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi Everyone,
this custom protective enclosure is specifically engineered for the ESP32-S3-DevKitC-1 (N16R8) development board with its pin headers fully soldered and accesso to buttons and leds.
Ideal for storage, transport, or standalone deployment.
Key Features
Full Pin Header Clearance: Designed to accommodate the complete board including standard male pin headers without bending or stressing the joints.
Auto-Locking Sliding Lid: The sliding cover glides smoothly into place and secures automatically via an integrated locking catch. To open it, simply lift the release tabs slightly and slide the lid back—no screws or tools required.
Integrated Button Actuators & LED Viewports: Built-in compliant buttons allow you to press the Reset (RST) and Boot switches directly from the outside, paired with dedicated sight holes to clearly monitor the onboard status and RGB LEDs.
Oversized Dual USB-C Access: The front cutout provides generous clearance around both the UART and native USB-C ports, ensuring full compatibility even with bulky or thick-molded USB-C cable housings.
RF-Friendly Windows: Dedicated cutouts positioned around the Wi-Fi/Bluetooth antenna and module area minimize signal attenuation and ensure reliable wireless performance.
Passive Ventilation: Integrated air vents promote natural airflow to dissipate heat during intensive dual-core processing or continuous Wi-Fi transmission.
Print Recommendations
Material: PETG is strongly recommended for the best elasticity and durability on the locking tabs and integrated button flexors ,PLA+/PLA works fine as well, mine is in PLA+.
Layer Height: 0.20 mm (or 0.16 mm for smoother sliding rails).
Infill: 20% (Gyroid or Grid).
Perimeters / Walls: 3 walls
Supports: Not required if oriented flat on the build plate.
That's All Folks!!!
Enjoy and happy printing! If you like this model, please leave a like and a comment with your makes.
Liked my model? Buy me a coffee or a beer to fuel my late night work on the next one!
