1 / 2
Gigabyte AI TOP ATOM 10" Rack Shelf with Dual 80mm Front Fans (2U, One Piece) — zdjęcie 1
1 / 2

Gigabyte AI TOP ATOM 10" Rack Shelf with Dual 80mm Front Fans (2U, One Piece)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

One-piece 2U 10" rack shelf for Gigabyte AI TOP ATOM with two 80mm front fans ducting air into the box. M4 threads.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
GNU General Public License v3.0

A 2U shelf that holds the Gigabyte AI TOP ATOM in a 10" mini rack. It was made for the DeskPi RackMate T1.

The ATOM pulls most of its cooling air in through its front grille. This shelf puts two 80 mm fans in the front panel. A printed duct behind them narrows onto the front of the box, and a soft foam strip on the duct's edge seals against it. The fan air goes into the ATOM's intake instead of spilling around it. Hot air leaves through the back as normal.

Features

- Faceplate, duct and tray print as one piece, with no screws joining parts.

- Modelled M4 threads for the fan screws, so no heat-set inserts are needed.

- The duct opening is sized for the ATOM's front face (plinth 5 mm, body 50.5 mm).

- The box slides in from the back and two snap hooks hold it. Side rails keep it centred.

- Fans can be swapped from the front with the shelf still in the rack.

- Mounts to the front rails like any 10" panel. Rear brackets bolt to the rear rails.

Printing (Bambu Lab P1S, 0.4 mm nozzle)

- Material: PETG, on the Textured PEI plate.

- Orientation: face down. The part is 250 × 88 × 205 mm, so it needs a 256 mm bed.

- Brim: 2 mm, outer only.

- Supports: tree, from the build plate only, under the 8 fan-seat pads. They come out through the fan openings.

- Layers: 0.2 mm, with 0.12 mm through the thread zone.

- Recommended: 4 walls, 20% gyroid. About 8 h 20 min and 316 g.

- Faster: 2 walls, 15% grid. About 7 h 10 min and 226 g.

- Use the included 3MF so all of these settings load. The bare STL opens with supports off.

Hardware (per shelf)

- 2× Noctua NF-A8 PWM (80 × 80 × 25 mm)

- 2× 80 mm fan guards

- 8× M4 × 30–35 button-head screws

- About 45 cm of 5 × 4 mm soft closed-cell foam strip

- 1 pair of rear brackets plus M4 bolts

- Rack screws and cage nuts

Notes

- Measure your ATOM's plinth height and body height before printing.

- Drive the first M4 screw in slowly by hand. If it's tight, run an M4 tap through once.

- Don't stop the fans while the ATOM is running: the front is closed except for the fans.

- Also available for the NVIDIA DGX Spark.

Tagi