1 / 18
Large *LOUD* Air Horn  - Screw Fit — zdjęcie 1
1 / 18

Large *LOUD* Air Horn - Screw Fit

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A VERY LOUD air horn/membranophone that uses a balloon as the diaphragm. A larger version of my small air horn. This…

Ocena
0 / 5
Polubienia
3
Pobrania
12
Wydruki
0
Wyświetlenia
58
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Outdoor Toys
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A VERY LOUD air horn/membranophone that uses a balloon as the diaphragm. A larger version of my small air horn. This is remixed from my LargeLOUD Air Horn / Membranophone to use screw in connections instead of push-fit (https://www.printables.com/model/1634689-large-loud-air-horn-membranophone-updated-19-oct-2). I've walked a line here between joint strength and keeping the thickness of the parts down. Functionality of the horn is the same as the push-fit version. All parts print with a .4mm nozzle on standard settings but you may need to run the screws in with some initial careful twisting. Reducing the layer heights in the thread foms using variable layers will give a much smoother fit.

Great at sporting events, but don't point it at others when you're too close - that would be a good way to "start a conversation" (it is VERY loud).

I tried a few of the other air horns/membranophones out there but they tended to hurt my ears too much as there was no rearward protection for the user, so I designed a system that incorporates a deflector on the ring that holds the membrane/balloon on to the body. It deflects the vibration from the rear of the diaphragm back toward the front of the horn. Still just as loud out the front, but much easier on my ears at the back.

Assembly is very easy:

Cut a piece of balloon and stretch it over the back end of the chamber (fully open end). Hold it in place while you place the deflector cap on to secure it. Once it's secure you can stop pressing on - it doesn't need to go all the way down. The tighter you stretch the balloon, the higher the pitch. I get louder results with a tighter stretch and with thicker balloons.

If using the diaphragm chamber and cap you will need to adjust the fit when screwing the cap down in order to get the best sound (just like a real air horn). A little harder to blow, but LOUDER! The 0.2mm diaphragm is easir to blow, but the 0,4mm is louder. The printed diaphragms tend to give a higher pitch than balloons.

Fit the horn into the other end of the chamber. Point it in a safe direction and blow into the mouthpiece.

There are three different sized horns here. The smaller one is much handier. The large one is a proper full mega-horn shape so amplifies properly and is definitely loudest. The medium 250mm horn is almost as loud as the full horn but will fit in a P1P, P2S, X1C etc. There is also an extension for the horn. The more extensions you add, the lower the pitch - also easier to blow as there's more back-pressure in the horn. Add three or four extensions and it sounds like a fog horn.

Designed so all parts will print without supports, but the large mega-phone horn can benefit from support just inside the rim.

Category: Toys & Games

Tagi