Voron V0.2 Trim Nuts complete build LDO / Formbot / Misumi 1515 extrusions no drop

Note this is a work in progress, I have not fully assembled the printer with these so there might be some mistakes.  The top hat is 100% tested.  

Frustration-free assembly of the Voron 0.2 Trim Nuts.  Trim Nuts meaning, a slide in trim and nut combination for the 1515 extrusions.  This makes them frustration free.

NOTE:  if you do need to put something else on the extrusion just take a 2.5mm - 2.7mm drill in a hand fixture and drill it by hand.  This is a simple solution to the frustrating problem of working with 1515 extrusions. 

Take a look at my other model (1875223) that has just the top hat parts. I included them in there so you can have a full reference.  You can import this right into the official Voron V0.2 step assembly if you need to.

There are two requirements for this assembly:
1 -  LDO / post V0.1 Formbot / Misumi profile extrusions.  They look like this:

2 -QTY:30   M3 X 8mm long bolts.


The step files are included as well as an assembly so you can always modify the design for your particular needs.

V0s come in two top hat sizes, 80mm and 100mm.  My top hat only model has the top hat specific parts organized in a 3MF.

Notes:

Printing at .12 layer height is optimal.  Printing them on a 45 degree angle with a brim seems to be best.

The short leg blanks have wings on them, it is not support.  When you slide them in, they will have a decent press and stay there since there are no bolts to hold them in place. 

The door handle trim is the only part here that does not use square inserts, they require you to self tap them with the original screws.