1 / 2
Closet Hanger Rod Holder — zdjęcie 1
1 / 2

Closet Hanger Rod Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Kit of Closet Rod Holders for a 1” trade size (1.3” OD) pipe. Including two wall mounts and the middle support(s).

Ocena
0 / 5
Polubienia
63
Pobrania
131
Wydruki
0
Wyświetlenia
395
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Bedroom
Licencja
Open Community License v1.1 + General Attribution v1

Closet Rod Support Set for 1″ Nominal Pipe — Reinforced End Sockets & 13″ Center Bracket

A coordinated set of printable brackets for building a closet hanging rod from galvanized steel pipe. The design combines reinforced end mounts with a triangular center support, using thick socket walls, gussets, and rounded transitions throughout.

Designed around pipe measuring approximately 1.33″ / 33.8 mm outside diameter, with 34.5 mm openings for fitting clearance. Check your actual pipe diameter before printing—nominal pipe size is different from its outside diameter.

Three complementary components

1. Closed End Socket
A fully enclosed socket that receives one end of the pipe. The rectangular mounting plate has four screw holes, two reinforcing gussets, and a rounded socket-to-plate junction. A 30 mm engagement depth supports the pipe end.

2. Drop-In End Socket
A matching open-top socket for the opposite wall. Insert the pipe into the closed socket, then lower the other end into this bracket. The full-width opening allows installation without flexing the bracket or forcing the pipe through a snap fit.

3. Wall-Mounted Center Support
A triangular bracket that positions the pipe centerline 13″ / 330.2 mm from the rear mounting surface. The center bracket prints in two sections that assemble using two sideways-sliding dovetail joints with closed end stops. The dovetail shoulders provide mechanical engagement, while a snug fit retains the sections along the assembly direction. No glue, metal reinforcement, or assembly bolts are required; wall-mounting screws are still necessary.

The center support mounts directly over a wood stud, with vertically spaced mounting holes and accessible screw locations.

Included files and features

● M3U files for the printable parts. In these files, the bolt holes are chamfered, and the regions around the holes use increased infill and additional perimeters for greater rigidity.

● STL files, if included, supplied in their intended printing orientations. Unlike the M3U files, the STL files do not include the increased infill or perimeter settings, and their bolt holes are not chamfered.

● Printing, mounting, and assembly instructions.

Printing and installation

Print one closed socket, one drop-in socket, and both sections of the center bracket. The supplied orientations are designed to print without supports. The largest section measures approximately 238 × 190 × 40 mm, allowing it to fit a Prusa MK4S.

For the strongest mounting points, use the M3U files with their specified chamfered bolt holes, increased infill, and additional perimeters around the holes. If using the STL files, apply equivalent slicer settings where possible and note that the bolt holes will retain their unchamfered geometry.

PLA is useful for checking dimensions and assembly; repeat the fit check in your final material. ASA was selected for the intended finished build.

Mount the end sockets to secure wood backing and the center support to a wood stud. Align all three supports to the same pipe-center height.

Load capacity: These files do not carry a verified working-load rating. Actual capacity depends on the filament, print quality, joint fit, mounting hardware, backing, and load distribution.

Tagi