1 / 2
Gridfinity 1x1 Key Fob Holder – VW Golf 8 / ID.3 / Škoda Octavia 4 / SEAT Leon — zdjęcie 1
1 / 2

Gridfinity 1x1 Key Fob Holder – VW Golf 8 / ID.3 / Škoda Octavia 4 / SEAT Leon

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Gridfinity 1x1 bin that holds the VW Group keyless fob upright, rotated 45° for sturdy walls. With or without magnets.

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
132
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

About

A Gridfinity 1x1 bin that holds the current VW Group 3-button keyless key fob – the newer fob without the flip-out key blade. The key stands upright, so it takes a single grid cell and is easy to grab.

It fits the fob used in the VW Golf 8, ID.3, ID.4 and ID.5, Škoda Octavia 4 and Enyaq, SEAT Leon 4, Ateca and Tarraco (2020+) and Cupra Leon and Formentor. It is not meant for the older flip key (Golf 7, Octavia 3). If your key looks the same, it will most likely fit – print the fit test first.

Design idea

The fob is about 40 mm wide, which is too much for a straight pocket in a 1x1 bin: it would leave a wall of only about 0.35 mm. Rotating the pocket by 45° uses the diagonal of the cell and leaves walls of about 2.5 mm, so the bin stays sturdy and still fits the standard grid.

Features

  • Gridfinity 1x1, height 5U: 41.5 × 41.5 × 35 mm, no stacking lip

  • Pocket 40.8 × 15.8 mm, 28 mm deep, rotated 45°

  • About 40 mm of the key sticks out for an easy grip

  • 0.6 mm lead-in chamfer on the pocket edge

  • Two versions: without magnets, or with holes for standard 6 × 2 mm Gridfinity magnets

  • 4 mm fit test slice with the same pocket

Files

  • vw_skoda_key_fob_gridfinity_1x1.stl – without magnets

  • vw_skoda_key_fob_gridfinity_1x1_magnets.stl – with magnet holes

  • vw_skoda_key_fob_gridfinity_1x1_fit_test.stl – optional, quick fit check

Print settings

  • Orientation: as provided, base on the bed

  • Supports: none

  • Nozzle 0.4 mm, layer height 0.2 mm

  • Walls: 3

  • Infill: 10 % gyroid

  • Top / bottom layers: 5 / 4

  • Brim: not needed

  • Material: PLA or PETG

Tips

  • Print the fit test first (a few minutes). The key should slide in freely without wobbling.

  • Magnet version: press the magnets in after printing. Add a drop of glue if they are loose.

Not affiliated with Volkswagen, Škoda, SEAT or Cupra.

Tagi