1 / 2
Dewalt DXCVXA06B vacuum to Milwaukee 49-90-1996 hose — zdjęcie 1
1 / 2

Dewalt DXCVXA06B vacuum to Milwaukee 49-90-1996 hose

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple adapter that allows a Milwaukee 49-90-1996 antistatic hose to connect to the Dewalt DXCVXA06B vacuum.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
23
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution — Share Alike

This is a simple adapter for the Dewalt DXCVXA06B battery powered vacuum to the Milwaukee 49-90-1996 antistatic hose.  I made this because the hose that comes with the Dewalt vac generates a lot of static.  The Milwaukee hose, straight pipe, and curved pipe are antistatic.

In the close-up photo, you can't actually see the adapter; what is shown is the Milwaukee connector and the Dewalt vac.  The adapter is what is holding the connector to the vac.  I didn't think to take a photo of my adapter when it was still on the printer.

Each end of the adapter is tapered; the more narrow end is for the Dewalt and the slightly larger end is for the Milwaukee.  Place the adapter into the Dewalt's inlet port, then tap it in with a mallet (plastic or rubber).  This is a simple press-fit adapter, it does not use the Dewalt click-lock nor the Milwaukee twist lock.  My intent is to install it once and never remove it.

I printed this with PETG so that it is stronger than PLA.  In the bgcode file, PETG is material #1.  I printed this on my Prusa 5XL.  I set it for solid with a circular fill (not XY cross hatch fill).  I used Hatchbox PETG black and set the bed temperature and extruder temperature for the PETG.

The attached PDF shows the model numbers for the piece-parts that I are in my photo.