Dewalt DXCVXA06B vacuum to Milwaukee 49-90-1996 hose
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple adapter that allows a Milwaukee 49-90-1996 antistatic hose to connect to the Dewalt DXCVXA06B vacuum.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Share Alike
This is a simple adapter for the Dewalt DXCVXA06B battery powered vacuum to the Milwaukee 49-90-1996 antistatic hose. I made this because the hose that comes with the Dewalt vac generates a lot of static. The Milwaukee hose, straight pipe, and curved pipe are antistatic.
In the close-up photo, you can't actually see the adapter; what is shown is the Milwaukee connector and the Dewalt vac. The adapter is what is holding the connector to the vac. I didn't think to take a photo of my adapter when it was still on the printer.
Each end of the adapter is tapered; the more narrow end is for the Dewalt and the slightly larger end is for the Milwaukee. Place the adapter into the Dewalt's inlet port, then tap it in with a mallet (plastic or rubber). This is a simple press-fit adapter, it does not use the Dewalt click-lock nor the Milwaukee twist lock. My intent is to install it once and never remove it.
I printed this with PETG so that it is stronger than PLA. In the bgcode file, PETG is material #1. I printed this on my Prusa 5XL. I set it for solid with a circular fill (not XY cross hatch fill). I used Hatchbox PETG black and set the bed temperature and extruder temperature for the PETG.
The attached PDF shows the model numbers for the piece-parts that I are in my photo.