Transport box for MiniMax RC Sailing Yacht

Transport box box for MiniMax sailing yacht, transmitter (Radiomaster Pocket), three rigs, battery, charger... 

• Integrated boat stand 

• lid_templates_1-3 are used to cut the clear plastic inserts for the inner lid

• box and lid printed with 0.6 nozzle @0,32 mm height

• inner lid printed with 0.6 nozzle 0.2 mm height 

Material needed:

• A4 sized 1 mm thick clear plastic sheet (PETG works best for printing on top)

• hinges and latches: 6 x M3x30 (flat head) or 4 x M3x30 and 2 x M3x40 (if you want to use the handle)

• attaching cradle front to cradle back: 5 x M3x10 (flat head needed, must not exceed 2 mm height) 

• attaching cradle to box: 2 x M3x10 | 2 x washer M3 

• about 15 cm 1,75 filament to attach inner lid to lid, just slide it in from the side into the hinges 

• 4 x magnet 10x2mm for closing the inner lid 

Slice the inner lid with layer height 0,2 mm, add a print stop @ 2 mm height and add the clear plastic inserts cut using the inside edge of the templates.
Resume printing and the printer will print directly on top of the plastic, welding it to the inner lid. You can use a bit of epoxy to hold the inserts in place but use it sparingly. Before printing make sure the inserts fit nicely inside of the templates with a little room to spare. Give the inserts a few moments to heat up on the paused print to get flat again.  

MiniMax sailing yacht was designed by Brett McCormack from Castlerock Yachtworks

If you want to build one yourself check out these resources: 

https://castlerock.bigcartel.com/

https://sailminimax.com/FAQs/

https://www.facebook.com/groups/4640208236250985/ (Facebook group with plenty of useful information and helpful people)