Stokke Tripp Trapp Tray Replacement Clip / Latch / Lock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A direct replacement for the bottom latch on the Stokke Tripp Trapp Tray (table) that clicks onto the Baby Set rail.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
### Required Hardware & Tools
* 3× M3 heat-set threaded inserts
* 3× M3 × 10 mm screws
* Utility knife / craft knife (e.g. Stanley knife)
### Preparation & Installation
1. Trim the broken latch: Cut off the remnants of the original broken plastic latch completely short and flush using a utility knife so the new clip can sit flat.
2. Install the inserts: Heat-set the 3× M3 threaded inserts into the existing holes on the underside of the tray (See photo for exact locations).
3. Mount the clip: Place the printed clip over the mounting points and fasten it with the 3× M3 × 10 mm screws.
### Print Settings
* Orientation: Print flat with the base on the build plate (latch sticking upwards).
* Supports: No supports needed.
* Material: PETG (recommended; much less brittle than PLA and handles repeated flexing).