1 / 2
Stokke Tripp Trapp Tray Replacement Clip / Latch / Lock — image 1
1 / 2

Stokke Tripp Trapp Tray Replacement Clip / Latch / Lock

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A direct replacement for the bottom latch on the Stokke Tripp Trapp Tray (table) that clicks onto the Baby Set rail.

Rating
0 / 5
Likes
0
Downloads
9
Makes
0
Views
32
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Attribution — Noncommercial

### Required Hardware & Tools

  1. * 3× M3 heat-set threaded inserts

  2. * 3× M3 × 10 mm screws

  3. * Utility knife / craft knife (e.g. Stanley knife)

### Preparation & Installation

1. Trim the broken latch: Cut off the remnants of the original broken plastic latch completely short and flush using a utility knife so the new clip can sit flat.

2. Install the inserts: Heat-set the 3× M3 threaded inserts into the existing holes on the underside of the tray (See photo for exact locations).

3. Mount the clip: Place the printed clip over the mounting points and fasten it with the 3× M3 × 10 mm screws.

### Print Settings

* Orientation: Print flat with the base on the build plate (latch sticking upwards).

* Supports: No supports needed.

* Material: PETG (recommended; much less brittle than PLA and handles repeated flexing).

Tags