1 / 2
Roof Mast Antenna holder for FP18 — zdjęcie 1
1 / 2

Roof Mast Antenna holder for FP18

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Attaches magnetically to a ferrous vehicle panel (roof on some cars, hood on others) to provide an anti-slip base

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
14
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Magnetic vehicle mount for Greenlee FP18 Collapsible 18' Cable Pulling and Reaching Fish Pole: https://www.amazon.com/dp/B0010BAE40

Magnets used: https://www.amazon.com/MUTUACTOR-Neodymium-Anti-Slip-Miniature-Equipment/dp/B07JLKXRV6

Expected holding: roughly 8–10 lb per magnet on a car roof, about 35–40 lb for all four, to keep the base from sliding; the guy lines carry the mast’s sideways load.

Assembly

Push each magnet into its pocket from below, stud up.

On top, use the included washer and nut to secure each magnet and tighten until snug without crushing the print.

Tagi