Thermalling gliders desk toy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Point the sun towards the gliders, and they will start thermalling.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 1267
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
Printing tips
Print the gliders' base with high infill (60-80%) because it also acts as a balancing weight. Use variable layer height and print the curved bottom surface as low layer height as your printer reliably can. 0.12mm will do, but the smaller, the better. Sand the surface after printing. The spinner will work without sanding, but it makes the toy spinning a lot smoother.
The material doesn't matter, I printed out of PLA except for the arms that are translucent PETG.
The logo on the top is my gliding club's logo. To print it in three colours, change filament at 0.8 and 1.4 mm. I used yellow on top of the blue to produce green.
Assembly
The toy requires two 10x4 or four 10x2 round neodymium magnets. Put two 10x2 or one 10x4 into the gliders' base and the same into the sun's base. Make sure that they repel each other. This is required for the toy to work.
Assemble all other parts. Most of them should friction fit except for the gliders on the arm. Use a drop of glue for them, but check the rotation direction before glueing.