1 / 4
CoralBoard SL VESA 75/100 & Wall Mount – Tool-Free Slide-On Keyhole Plate — zdjęcie 1
1 / 4

CoralBoard SL VESA 75/100 & Wall Mount – Tool-Free Slide-On Keyhole Plate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount the CoralBoard SL case behind a monitor (VESA 75/100) or on a wall: the case slides onto printed pegs, no tools.

Ocena
0 / 5
Polubienia
2
Pobrania
1
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Apache License 2.0

A mounting plate for my CoralBoard SL Snap-Fit Case (separate model, linked in my profile). Screw the plate to the back of a monitor or TV (VESA 75 x 75 or 100 x 100) or to a wall, then hang the case on it: four printed mushroom pegs go into the keyholes in the case floor, and the case slides down 7 mm and locks. Lift it up and off whenever you need the board back on your desk.

Perfect for an always-on edge-AI demo: a camera or display project running on the CoralBoard behind a screen, a sensor hub on the wall, or a kiosk.

FEATURES

  • VESA 75 and VESA 100 hole patterns, countersunk for M4 screws.

  • - Two extra countersunk holes for screwing it straight to a wall (4 mm / #8 screws).

  • - Four printed pegs that match the keyholes in the case floor. No tools needed to attach or remove the case.

  • - When it hangs, the ports face down, so cables drop neatly and the board stays reachable.

  • - Cable pass-through in the middle, plus lightening slots.

  • - Checked in CAD: the pegs clear the case at both the entry and the locked position, and clear the board.

SIZE: 112 x 112 mm, 4 mm plate (7.9 mm including pegs)

HARDWARE

  • 4x M4 x 10-12 mm countersunk screws for VESA (check your monitor's thread), or

  • - 2x 4 mm / #8 countersunk wood screws and wall plugs for a wall.

PRINTING

  • PETG recommended (PLA works for light duty), 0.2 mm layers, 4 walls, 30% infill, no supports.

  • - Print flat with the pegs facing up (the files are already oriented this way).

USE

  1. Screw the plate to the monitor or wall with the pegs facing out and the cable hole roughly centred.

  2. 2. Hold the case with its ports facing down, put the four keyholes over the pegs and slide it down until it stops.

FILES

  • STL and 3MF for printing, STEP for editing, and the full Fusion design (.f3d) with the case, the mount and the reference board.

Board reference CAD: Synaptics Coralboard SL by Coral (Apache-2.0). Designed with AI assistance (Claude) and modelled in Autodesk Fusion.

Tagi