Modular Pegboard Bins – S/M/L, Sloped Front, Label Slot (1" pegboard)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Three sizes of support-free bins for standard 1" pegboard. Lock-in hooks, anti-wobble pegs, sloped front, label slot.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 31
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
A family of three hanging bins for standard 1-inch (25.4 mm) pegboard with 1/4" holes. Mix and match them to keep screws, electronics parts, hobby supplies, 3D-printing spares or office bits right where you can see and reach them.
SIZES
S (2 holes wide): 49.6 x 45 x 40 mm outside (W x D x H)
- M (3 holes wide): 75 x 60 x 50 mm
- L (4 holes wide): 100.4 x 70 x 60 mm
Every bin is exactly 1.2 mm narrower than its grid width, so bins can hang side by side on neighbouring holes with no gap problems.
HOW IT ATTACHES
Two L-hooks on the top row pass through the pegboard and turn up behind it, so the bin can't be lifted off by accident.
- Two round anti-wobble pegs one hole lower stop the bin swinging or tilting when you grab something.
- Round 5.8 mm shanks fit 1/4" (6.35 mm) holes, and the hooks clear boards up to 6.6 mm thick (1/8" and 1/4" hardboard).
- Checked in CAD against a 1" pegboard model: no interference in the hung position.
- To hang: tilt the bin, hook it into the top holes, then swing it down so the lower pegs drop in.
DESIGN DETAILS
Sloped front so it's easy to reach in and see what's inside.
- Label recess on the front (60 x 9 mm, 0.6 mm deep) for a printed or handwritten label, or a strip of tape.
- Rounded inside corners so small parts are easy to scoop out.
- 1.8 mm walls and floor, 3.2 mm back plate.
PRINTING
PLA or PETG, 0.2 mm layers, 3 walls, 15% infill, no supports needed.
- Print as supplied: floor on the bed, back plate vertical. The hooks stick out sideways as short horizontal bridges, which print cleanly and make the hooks strong (the layer lines run along the hook, not across it).
- The 3MF files are ready for PrusaSlicer, Bambu Studio or OrcaSlicer.
FILES
STL and 3MF for each size, STEP for remixing in any CAD tool, and the Fusion design (.f3d) with all bins, the 3D-printing tool caddy and a pegboard reference panel.
Designed with AI assistance (Claude) and modelled in Autodesk Fusion.