Desk Organizer [Side mount]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
[Desk Side Mount Organizer V2] Designed to clamp onto the side of table/desk/tabletop with 2 tightening bolts
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 750
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
[Desk Side Mount Organizer V2]
Designed to secure onto the side of table/desk/tabletop with 2 tightening bolts, offering extra real estate for organizing your working place.
24 June 2023: updated to V2
-Improved support at clamping area
-Expanded tray section size
-Added a larger foothold for bolt
----------------------------------------------------------------------------------------
[V1.1] It has 4 storing compartments: phone dock, 2 HDXC/HDSC card slots, general holder (print separately) and a tray section.
It is designed to fit onto table/desks that are at max 2.3cm or 0.9 inch thick (see attached picture) - someasure before you print.
There are 4 parts: main body, a holder and 2 tightening bolts.
Important
Slowly adjust the bolts until they just grab onto the surface, do not overtighten them as it may crack at the joint (another 20 meters of filament down the drain). Better yet, use tougher materials like PETG.
Slicing
Print the main body with bottom face up, enable support, and add support blockers at the SD card slots (See below).
Print the bolts with higher infill rate.
Cura preview
(Note the support blocker in the middle section)
Category: Organization