[Ender 5 S1] Cable Holder + Cable Spine fusion!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ender 5 S1 remix of cable spine and cable holder, extending the life range of the printer ribbon cable effectively
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 26
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A remix of the Ender 5 S1 Cable Holder and the Ender 5 S1 Cable Spine, where both parts are fused together preventing the ribbon cable from extremely bending in between the ends of both pieces.
This remix allows you to use the best of both worlds:
A twisted, fit-in-place cable holder
A spine-like structure to greatly delimit the ribbon cable moves
The connector is exactly the same as the spine blocks, so it just snaps together! Tested so far with awesome results
Print Settings
Recommended PETG because of the mechanical stress the component is under, but not strictly needed (PLA just works fine as the range of movement is quite short). The print follows the same settings as the original models, slightly tweaked:
Print height:
0.2 mm, smaller may yield better looking results, but not strictly needed.Infill:
15%is enough, as most are walls. Not critical.Walls:
3, more robust piece.Support: not needed, but make sure your fan is 100% when printing overhangs and the enclosure, if any, is fully open.
Adhesion: can work without adhesion, but I highly recommend using Brim: the piece is bigger than the original with more mass place at the very top. High risk of unwrapping due to head movements.
PS: If you see in the photos my print is slightly rugged, it's because I printed with the cooling fan disabled so the overhangs melted.