Logitech Z200 Horizontal Speaker Stands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement for the integrated stands on the Logi Z200 speakers
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
About
These stands fit Logitech Z200 speakers and allow them to be more usefully mounted horizontally, or optionally attached to a different flat surface.
Prepare
You will need to remove the integrated stands to use these. Each speaker is held together by 8 screws. The Right speaker also has a nut and washer under the volume knob that will need to be removed.
Once inside the speakers, there are four screws that hold in the integrated stand. After removing these, the stand can be carefully spread open and removed. It is latched into the top of the speaker also.
Print two stands, one a mirror image of the other.
Print four of the small D-shaped inserts for each speaker and screw them in place where the four stand mounting ears used to go. This is important since the speaker needs to remain airtight to retain its bass performance, and the small screw holes will leak.
Assemble
You can simply slide the speaker onto the stand if you intend to use the speakers horizontally.
For more permanent installation, the stands include a hole for a screw to fasten the speaker to the stand. Using the stand as a guide, drill a 2-2.5mm hole in the back of the speaker, and use a 3mm diameter x ~5mm screw (preferably a sheet metal type) to fasten speaker and stand together.
Optionally, you can use a small square of double-sided tape in the square depression on the stand.
The stands also include two holes in the base to allow the speakers and stands to be bolted to a surface.