HHO generator
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
water is boring and the good stuff is behind a paywall 1.23 Volts, pay that fee righ now with this cell.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Chemistry & Biology
- Licencja
- Creative Commons — Public Domain
This is an oxy-hydrogen electrolisis cell, you might have heard of it as a magical device that creates fuel out of water..... thats bs.
Safety and general tips:
Do a little research on safety precautions when dealing with caustic solutions, for HHO cells don't use a acid elelctrolyte, and be responsible when handling the HHO mixture, if you are planing on using NaOH as you electolyte make sure that every 3d print that touches it is either made of PE or PA, don't try to 3d print the PVC pipe that is just an increased risk of leaks and use sealent across the whole bottom and top caps not just on the mates.
Hardware:
You can use any power supply you want just make sure you are getting around 1.9-12 vots per cell, when using higher voltages i.e. >4V be mindfull of efficinecy losses wich get converted into heat wich you 3d prints nor you electrolyte want, but it should be fine for short runs as there is plenty of thermal capacity as you will use around 600ml of electrolyte per cell. The bracket is made for HP server power supplies wich are probably the best afordable high current power supplies you can get, they are much easier to handle and get runing than something like a microwave transformer, DON'T buy them new you can get them sometimes as low as 1200W for 20$ from crypto mining, don't be affraid of buying a used PSU you are not building a PC with it, if you can buy from a seller who can sell you multiple PSUs of the same model, joining their output is much easier than if they are dissimilar. These PSUs won't turn on when you connect power, most of the times just short the first 3 small gold plates on the edge of the board, drop a solder drop there its easier to swithch power upstream of the PSU. I know high current is fun to play with, just make sure that if there is an overcurrent protection shut off let the PSU rest for at least 5 minutes, l already killed one just by turning it on again.
There is around 1000cm^2 of electrode area, when using 316 stainless as a electrode so thats good up to around 500A or 5 1200W PSUs, i will be using only 200A as that way there is less heating and more efficiency, if you are thinking of runing with the full 500A make sure you are not using higher voltages, stick to under 3V and consider a electrolyte coller.
If you are using 304 stainless consider lowering the current, 300A should be your maximum for prolonged exposure, don't consider any other electrode material, nickel and anything more noble is overkill and most other metals leave you with a chemical goo after some minutes, wich if you are burning the HHO turns this clean flame into a chemical hazard on the chemical hazard side don't use table salt that decomposes into chlorine, if you want a less harmfull electrolyte than NaOH use NaHCO3 i.e. baking soda