The Towering Inferno Incense Burner

I designed this due to needing one, then after downloading and printing a few different models of burners and found that the ash just seemed to miss the collection tray, or the sticks wouldn't sit in the holder correctly, or both.

My desire for a reliable burner led me down the path to create my own, with the two main issues I experienced at the forefront of the list.

As a result, I present the Towering Inferno. The name Towering Inferno is a reference to the movie, as the burner looks like a skyscraper on fire with smoke billowing from the windows.

To combat the issues I was experiencing, I designed the slots of the main frame on a 45 degree angle. This prevents the ash from falling outside of the perimeter of the internal ash tray, and as a secondary feature allows the smoke to escape easily.

When placing the frame ensure that the side with the word TOP is up, if not, the ash will make a mess on your surface.

There are three main variations of this model.

1.5mm sticks
2.0mm sticks
2.5mm sticks

I have found that the 2.0mm base fits the majority of the sticks that I have purchased. Each size variation has four different bases.

Simple with no storage
Left side stick storage
Right side stick storage
Rear stick storage

Both the left and right variations allow for the sticks to be stored at either the front L/R side or the rear L/R side, effectively allowing for six variations. You simply decide which variation you prefer, and print it. The images provided show all of the variations possible to assist you with making a decision.

The model is in three sections, the base, the main frame, and the topper. There are two variations of the topper provided, one sealed, and one slotted.

You can also use incense cones with this burner. Simply place cone dish on top of the base where the sticks are usually placed as a form of insulation from the heat.

I have provided some test pieces. These are printed beforehand to ensure that the inner and outer parts of the burner fit correctly before sending to print. The thinner square on the test plate represents the frame. If you have to adjust the frame, write down the percentage that you increased the frame test ring, reprint it, then test it against the base test ring already printed.
You can then confidently print the burner knowing that everything is to the correct proportion.
There are also stick diameter test pieces to ensure that the size you select will fit the sticks that you have.
A little bit of filament before committing may save you some money and a headache.

I printed this out with a 0.2mm layer and received barely any noticeable stepping. I don't think going lower will achieve much difference, but it's your filament, and your choice. I also printed this in PLA, but if you choose a different type of filament or even a silk, those settings I suggested may not be applicable.

You are also not required to use supports at all with any of the pieces. I personally use a cryogenic plate so I cannot say whether to print with or without brims. That one is your call. I will admit that if you are using a Cartesian style printer, brims may be a safe bet on the frame due to its height.

The model has a simplistic contemporary feel about it, which would suit any décor setting where it’s placed. If you print this out, please post some photos of your colour choices. This will help give others some ideas and inspiration.

Likes are greatly appreciated, but this is another upload that I don't care what you do with it. Remix it, sell it, give it away, I don't care. Just have fun with it, and enjoy.