Bigscreen Beyond 1/2 OBSBOT Meet SE Passthrough Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount to attach an OBSBOT Meet SE to the front of your BSB to act as a passthrough camera.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Was looking for a camera to use with my BSB and MRGO and found the OBSBOT Meet SE, which was small, light, and had a high frame rate (There is also the OBSBOT Meet 2, which is 4k60 and I believe it is the same dimensions, but I don't have it to try).
I printed this on my Bambu X1C with tree supports, with the camera mount part facing down; it took about ~1 hr. The supports were a bit of a pain to remove, but the final product was pretty good, and it was possible to get at all the support material off. I haven't tested this extensively, so I'm not sure about how strong it is. The orientation I printed it in could pose some structural issues with shear force on the bits that connect the camera mount to the BSB mount.
I'll try to get a better picture of it eventually.
Low-profile USB-C cable: https://www.amazon.com/dp/B0DQ8B8PFR