Bigscreen Beyond 1/2 OBSBOT Meet SE Passthrough Camera Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount to attach an OBSBOT Meet SE to the front of your BSB to act as a passthrough camera.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 0
- Makes
- 0
- Views
- 34
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Was looking for a camera to use with my BSB and MRGO and found the OBSBOT Meet SE, which was small, light, and had a high frame rate (There is also the OBSBOT Meet 2, which is 4k60 and I believe it is the same dimensions, but I don't have it to try).
I printed this on my Bambu X1C with tree supports, with the camera mount part facing down; it took about ~1 hr. The supports were a bit of a pain to remove, but the final product was pretty good, and it was possible to get at all the support material off. I haven't tested this extensively, so I'm not sure about how strong it is. The orientation I printed it in could pose some structural issues with shear force on the bits that connect the camera mount to the BSB mount.
I'll try to get a better picture of it eventually.
Low-profile USB-C cable: https://www.amazon.com/dp/B0DQ8B8PFR