SKADIS Hidden battery dispenser / pen container / magnet board / vase.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A SKADIS compatible battery dispenser hidden inside a selection of containers, and magnet boards on the front.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
Description
I wanted a battery dispenser for the rechargeable batteries I'm always putting in my kids toys. My wife thought it didn't look nice enough to have on our home office wall. So I made some hidden versions inside pen containers and vases, and I added free moving magnetic inserts on the front.
The battery dispensers parts come in 4 version:
8xAA
12xAA
8xAAA
12xAAA*. *I haven't tested the 12xAAA model yet, so I will upload it after printing and testing.
I am uploading the following containers, and I will upload more after testing them:
8xAAA pen container (small)
8xAA Square pen container
12xAA Square container (tall)
12xAA Round container (tall)
12xAA vase (print in vase mode), and a vase mode adapter to attach the vase onto the battery dispenser. The neck of the vase was a little bit too small so I will make another version as soon as I can.
I will try to upload the necessary files and instructions to make it easier for others to create their own container and vase designs for the system as soon as I can.
Printing
All the models I am uploading, except the vase (print on vase mode), I have printed and tested with the following setting on my trusty old MK3, that I assembled 6 years ago and haven't maintained or tuned since:
Material: PLA
Nozzle: 0.4mm
Layer hight: 0.2mm (QUALITY and SPEED) both worked well.
Infill: 20%
Please pay attention to the print orientation, as I have done my best to optimise each part for strength (layer adhesion) in that orientation.
Supports: I have done my best to design all parts to print without support. I have added small breakaway tabs on the left and right side of the battery dispensers, and on the battery lids. These break away by hand.
Brims: Prusa slicer gives me low bed adhesion warnings for a few parts (especially the release latches), but I have printed everything except the vase multiple times with no supports or brim and haven't had any problems.
Hardware
The only non printable hardware required is the magnets. I designed the magnet spacers for 3x10mm round magnets but any magnet 3mm thick or thinner will fit into the slots (except the vase where I miscalculated and could only fit smaller 2x8mm magnets). The magnet spacers are to stop the magnets in the slots from sticking to each other so they can move around independently. I still need to test the ones for the round containers and design some flexible ones for the vase. Please let me know if there are other common magnet sizes I should make spacers for.
I didn't make a water container for the vase yet, so I used part of a small PET bottle to put the roses in. It's not needed for the lego flowers :).
p.s. No jokes about flowers and batteries being all the misses needs. :P