1 / 6
SKADIS Hidden battery dispenser / pen container / magnet board / vase. — image 1
1 / 6

SKADIS Hidden battery dispenser / pen container / magnet board / vase.

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A SKADIS compatible battery dispenser hidden inside a selection of containers, and magnet boards on the front.

Rating
0 / 5
Likes
3
Downloads
4
Makes
0
Views
48
Reviews
0

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution — Noncommercial

Description

I wanted a battery dispenser for the rechargeable batteries I'm always putting in my kids toys. My wife thought it didn't look nice enough to have on our home office wall. So I made some hidden versions inside pen containers and vases, and I added free moving magnetic inserts on the front.

The battery dispensers parts come in 4 version: 

8xAA

12xAA

8xAAA

12xAAA*. *I haven't tested the 12xAAA model yet, so I will upload it after printing and testing.

I am uploading the following containers, and I will upload more after testing them:

8xAAA pen container (small)

8xAA Square pen container

12xAA Square container (tall)

12xAA Round container (tall)

12xAA vase (print in vase mode), and a vase mode adapter to attach the vase onto the battery dispenser. The neck of the vase was a little bit too small so I will make another version as soon as I can.

I will try to upload the necessary files and instructions to make it easier for others to create their own container and vase designs for the system as soon as I can.

Printing

All the models I am uploading, except the vase (print on vase mode), I have printed and tested with the following setting on my trusty old MK3, that I assembled 6 years ago and haven't maintained or tuned since:

Material: PLA

Nozzle: 0.4mm

Layer hight: 0.2mm (QUALITY and SPEED) both worked well.

Infill: 20%

Please pay attention to the print orientation, as I have done my best to optimise each part for strength (layer adhesion) in that orientation.

Supports: I have done my best to design all parts to print without support. I have added small breakaway tabs on the left and right side of the battery dispensers, and on the battery lids. These break away by hand.

Brims: Prusa slicer gives me low bed adhesion warnings for a few parts (especially the release latches), but I have printed everything except the vase multiple times with no supports or brim and haven't had any problems.

Hardware

The only non printable hardware required is the magnets. I designed the magnet spacers for 3x10mm round magnets but any magnet 3mm thick or thinner will fit into the slots (except the vase where I miscalculated and could only fit smaller 2x8mm magnets). The magnet spacers are to stop the magnets in the slots from sticking to each other so they can move around independently. I still need to test the ones for the round containers and design some flexible ones for the vase. Please let me know if there are other common magnet sizes I should make spacers for.

I didn't make a water container for the vase yet, so I used part of a small PET bottle to put the roses in. It's not needed for the lego flowers :).

p.s. No jokes about flowers and batteries being all the misses needs. :P

Tags