Flush Spike Cap for Hooch Multi-Base V3 (Non-Stackable 90mm Round Pipe Base)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap-in spike cap for the Hooch Multi-Base V3 opening. Sits flush and holds a grow spike centered.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
Flush Spike Cap for the Hooch Multi-Base V3
A cap for the centre opening of the Hooch Multi-Base V3 – Non-stackable 90mm Round Pipe Multi-Base (Part 03, 255 × 255 × 102mm). It's for builds where you aren't using the root basket (Part 15) in that opening. It closes the opening and holds a grow spike in the middle.
This is an add-on, not a standalone model. The base and the spike aren't included here. You need to get them separately from Hooch.
Features
Sits flush with the top of the base, in the 53mm counterbore.
Snap-in clip tabs: two flexible hooks catch under the ledge inside the opening, so it stays put without glue.
Spike seat: a 24mm hole for the ~22mm spike tube, with a recess for the 28mm collar so the spike sits flush too.
No supports needed.
Dimensions
Cap: 52.6mm wide, 11.5mm tall
Spike hole: 24mm
Collar recess: 28.8mm wide, 2.2mm deep
Designed for an opening with a 53mm counterbore (2mm deep), a 48.2mm bore, and a ledge 8mm below the top face.
Print settings
Orientation: flush face (the flat top) down on the bed, skirt pointing up
Supports: none
Material: PETG recommended, since the tabs flex about 0.6mm. PLA may work but is more likely to snap.
Layer height: 0.2mm
Walls: 3+ (the tabs are only 1.5mm thick)
Infill: 20% or more
Fit tuning
The .scad source is included. If the cap is too tight or too loose, change these values and re-export:
cb_d: disc diameter (fit in the counterbore)
skirt_od: skirt diameter (fit in the bore)
hook_r: how far the hooks stick out (clip tightness)
Notes
Tested: printed and fitted on the Hooch Multi-Base V3 Part 03. It snaps in and sits flush.
This is a one-shot snap fit. Push it in straight and don't flex the tabs repeatedly.
Designed for the Hooch Multi-Base V3 Part 03 opening. It's not tested on other bases.
Compatibility
This is an original design, modeled from scratch in OpenSCAD, and it doesn't include any Hooch files. It's made to fit the Hooch Multi-Base V3 – Non-stackable 90mm Round Pipe Multi-Base and the Hooch grow spike
