1 / 9
Pipe clamp set 12 to 40 mm: snap-in clips and two-part clamps — zdjęcie 1
1 / 9

Pipe clamp set 12 to 40 mm: snap-in clips and two-part clamps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

20 holders for 12 to 40 mm pipes and conduit, each as a snap-in clip and a two-part clamp. No supports needed.

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
20
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

20 holders for pipes with 12, 15, 16, 18, 20, 22, 25, 28, 32 and 40 mm outside diameter, which covers common copper and plastic pipes and M16 to M32 electrical conduit. Every size as a snap-in clip and as a two-part screw-down clamp. Snug fit: the opening is 0.3 mm larger than the pipe. Fixed with 4 mm wood screws.

Printing: front face down, as in the file. Every layer is a complete ring. PETG recommended because it is less likely to break when you snap a pipe in.

No load figure: how well a clip holds depends heavily on the print. Not for hot or safety-critical lines.

A table of all sizes is in the pictures. Need a size that is not included? All files come from a free browser generator: https://timobritz.de/en/3d-druck/rohrschelle/

The first picture and the last ones are photos of my own prints. The others are AI-generated and show the parts as examples. The files and the table are what counts.

Tagi