Jaguar X300 XJ6 Fuel Pump Mount (NNA6025BA)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X300 XJ6 Fuel Pump Mount
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'm adding fuzzy skin to the "required" list, it helps immensely with PETG. Unknown for TPU but I assume it's the same.
This is a replacement for the rubber fuel pump mounts/collars for the Jaguar X300 (XJ6/XJ12/XJR). As I recently found out, they're basically no longer available from anywhere, and the few used ones I've seen are quite a bit of money for a small piece of rubber.
The mount is designed so that the opening for the pump is ever so slightly smaller than the pump neck itself, and has slots cut into the retaining ring allowing it to flex outward and grip the pump, with also a slot cut for a zip tie to make sure it stays tight.
JLM12204 (OEM) and Airtex E8285 (replacement) are the two fuel pumps I have based my measurements off of.
Filament: PETG or 95-98a TPU
Notes:
From my half dozen or so prototypes, I recommend these settings that yielded the best results on my Ender 3 Pro with Cura as my slicer:
Infill: 40-50+% with PETG (I used 50%, anything lower than 35% or so felt brittle). Unknown for TPU but may as well go solid (with walls) so it'll flex as little as possible
Infill pattern: Cubic and Gyroid are the two I've had the most success with
Layer Height: 0.12-0.2mm
Wall line count: 5 (just up it to make it solid with TPU)
Top/Bottom Thickness: 0.8mm works fine, more also works fine
Top/Bottom Pattern: Concentric
Bottom Initial Layer: Concentric
Fan Speed: I kept mine low/off to hopefully increase layer adhesion with PETG, unknown for TPU
Fuzzy Skin: Printing with fuzzy skin gave the inner pump mount surface much more grip. My skin settings were: 0.3mm thickness, 1.25 1/mm density, 0.8mm point distance, outside only
Post-Printing
Installation Instructions
- Remove support material from zip tie cut out
- Orient the mount so that the opening is centered with the electrical connector side of the pump, opposite to how it would normally go on the car.
- Use thumbs to gently slightly pry mount open, push the mount down onto the pump.
- Put a fuel safe zip-tie/cable-tie into slot, secure reasonably tightly
- Slide pump mount off, tighten zip-tie another 3 or so clicks
- Repeat step 3, trim end off of cable tie
OPTIONAL BUT RECOMMENDED: I personally am putting a thin coating of JB Weld (or any other fuel safe epoxy would work I suppose) on the pump mounting surface, just to make sure it never comes loose again
Category: Automotive