Liczymy pasujące modele…
Replacement for rubber mounting grommets that hold the side panels on my 1982 Yamaha Maxim XJ650 J and other similar motorcycles. These esoteric rubber parts tend to stiffen and crack before other parts wear out on these now ~40-year-old…
Replacement for the rubber relay holder under the gas tank on my 1982 Yamaha Maxim XJ650 J and other similar motorcycles. These esoteric rubber parts tend to stiffen and crack before other parts wear out on these now ~40-year-old…
When restoring a Turbo Seca (XJ650LJ) i picked up, i could not find a replacement air filter since the air box is only for this model (turbo version) made for two years. So i bought one that would fit within the air box from a Moto Guzzi…
The diameter of the inner circle is 31.70mm so in theory it might also work on any motorcycle with the same fork diameter. Print this with TPU only!
Replacement for the rubber wire terminal boots found on the solenoid-to-starter-motor cable and other places on my 1982 Yamaha Maxim XJ650 J and other similar motorcycles. These esoteric rubber parts tend to stiffen and crack before other…
I'm adding fuzzy skin to the "required" list, it helps immensely with PETG. Unknown for TPU but I assume it's the same. This is a replacement for the rubber fuel pump mounts/collars for the Jaguar X300 (XJ6/XJ12/XJR). As I recently found…
Part Number: 16G-26143-00
xj650 side panels I have not printed the right side yet due to out of filament but should work. print the right side at your own risk :) and tell me how it goes. the left side was printed at 100 infill with supports everywhere. will fit…
The 2 lenses of the interior ligth (l;eft and right) where slowly decaying. So i draw some lenses to print them and replace them. If have printed them in clear petg and standing up with minimal support. Place the part on the face in your…
Slouzi pro nalisovani kuzelikovych lozisek do hlavoveho slozeni na motorce. Podlozit oriskem z goly a stahnout zavitovkou.
If you're like me and were almost done with your carb clean/rebuild for... a while, you might also be like me and want a plug to keep critters from crawling into your engine via the intake boots. I swapped out the shop rags stuffed in the…
The plastic interior lamp holder in my jaguar xj6 series ii completely fell apart. So i draw a new one. The position of the holes is measured from my car. I printed it in PETG en the lamp now used is a LED lamp. Hopefully it will not get…
xj650 side panels I have not printed the right side yet due to out of filament but should work. print the right side at your own risk :) and tell me how it goes. the left side was printed at 100 infill with supports everywhere. will fit…
Simple mounting in the side plastic part of the xj6 motorcycle. Print ABS as parts of motocycle.
This is just a mock up part I'm uploading for the sake of a forum post. It's will fit loosely and not work well
