1 / 1
Popup Servo Mount — zdjęcie 1

Popup Servo Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a servo mount which enables the servo to be easily accessed as an alternative to gluing the servo in place.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

The Popup 9g servo mount.

This tilting mount was designed to enable 9g servos to be installed into model wings without the need for gluing which can cause problems when a servo needs to be replaced.

There are 2 parts to the tilting mount, a fixed frame which is glued into the servo recess and an attached tilting frame which the servo is fixed to and is itself clamped to the fixed frame by 2 M2 self tapping screws

The whole assembly will fit into a 42 x 40 x 12.5 deep pocket and the servo can then be replaced by simply removing the 2 M2 clamp screws, tilting the servo assembly upwards and removing the servo.

This also means that the servo arms can be repositioned or replaced, which is impossible if the servo is glued in place.

The pocket depth is only limited by the thickness of the servo.

I have included several alternative covers to choose from, they print well on edge using a brim.

The Popup frame itself is a print in place file and is ready to use straight off the printer table with minimal cleaning up, I used a Bambu Lab P1s printer and Bambu Basic PLA filament.

The picture is of an original mount design which used a 2mm piano wire pivot and is shown in contrasting colours for clarity, the current file will now print in place without supports and is ready to use straight off the print table.

20% infill

Tagi