1 / 1
Popup Servo Mount — image 1

Popup Servo Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a servo mount which enables the servo to be easily accessed as an alternative to gluing the servo in place.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
17
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

The Popup 9g servo mount.

This tilting mount was designed to enable 9g servos to be installed into model wings without the need for gluing which can cause problems when a servo needs to be replaced.

There are 2 parts to the tilting mount, a fixed frame which is glued into the servo recess and an attached tilting frame which the servo is fixed to and is itself clamped to the fixed frame by 2 M2 self tapping screws

The whole assembly will fit into a 42 x 40 x 12.5 deep pocket and the servo can then be replaced by simply removing the 2 M2 clamp screws, tilting the servo assembly upwards and removing the servo.

This also means that the servo arms can be repositioned or replaced, which is impossible if the servo is glued in place.

The pocket depth is only limited by the thickness of the servo.

I have included several alternative covers to choose from, they print well on edge using a brim.

The Popup frame itself is a print in place file and is ready to use straight off the printer table with minimal cleaning up, I used a Bambu Lab P1s printer and Bambu Basic PLA filament.

The picture is of an original mount design which used a 2mm piano wire pivot and is shown in contrasting colours for clarity, the current file will now print in place without supports and is ready to use straight off the print table.

20% infill

Tags