Gridfinity 14mm and 18mm Bowl Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity holders for 14 mm and 18 mm male bowls, with tapered holes like a glass joint.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Gridfinity holders for 14 mm and 18 mm male bowls.
The holes are tapered like a glass joint, so the bowl sits centered and the head rests on top instead of wedging in. Depth doesn't really matter with the taper.
Five versions:
- 1x1 single, 14 or 18
- 2x2 for six bowls with heads up to about 26 mm, 14 or 18
- 2x1 with one 14 and one 18, for bigger bowls up to about 31 mm. The 14 side is sunk 15 mm lower so a bowl with a handle on the 18 side can sit over the one next to it
Printed in PLA at 0.3 mm with no supports.
Built on the Gridfinity system by Zack Freedman (gridfinity.xyz).